James River — Howardsville to Scottsville: River Level Today — Can You Paddle It?
Verdict · updated Oct 18, 9:15 AM UTC
Good to paddle
Levels are within the typical runnable range for this section.
Estimated range
1,370 cfs
3.6 ft gauge height
USGS gauge 02029000
Runnable 500 – 10,000 cfs
What this means today
At 1,370 cfs the James River is inside the runnable range but only 870 cfs above the 500 cfs floor, so it is sitting at the shallow end of what this reach runs at. A dry few days would take it under.
Over the last 24 hours it has gone from 2,190 cfs to 1,370 cfs, 37% down. Daily means over the past 7 days have run between 712 cfs and 7,710 cfs, 158% higher at the end of the week than the start. The last day and the week as a whole point opposite ways, which usually means a recent rain bump on top of a longer rising trend — worth a second look at the chart before you commit to the drive.
Paddling Howardsville to Scottsville
James River at Howardsville to Scottsville is a 13-mile Class I run in Virginia — easygoing moving water with light riffles and nothing technical. Most paddlers put in at Howardsville Landing (Rt 602) and take out at Scottsville / Rt 6 Landing, a trip that runs about 6 hours at a relaxed pace.
Whether it's worth the drive comes down to flow. This section generally paddles well at 500–10,000 cfs (a conservative estimate — see our methodology). Much below that and the James River gets low and bony, so you end up scraping gravel and walking the shallows; well above the top of the range it turns fast, cold and pushy, which is a more serious day than most casual boaters want. We read USGS gauge 02029000 about every 30 minutes and compare the live number to that window, so the verdict at the top of this page reflects conditions right now rather than a monthly average.
Flows here are usually most dependable April–October. Spring can run high after rain or snowmelt, and late summer often drops too low to float well — but the gauge always beats the calendar, so check today's reading before you go.
7-day flow trend
Section facts
- Difficulty
- Class I
- Length
- 13 mi
- Float time
- ~6 hr
- Best months
- April–October
- Put-in
- Howardsville Landing (Rt 602)
- Take-out
- Scottsville / Rt 6 Landing
Reading USGS gauge 02029000 — JAMES RIVER AT SCOTTSVILLE, VA ↗ · runnable range is an estimate (see methodology)
FAQ
- What water level is good for paddling James River — Howardsville to Scottsville?
- This section is generally runnable at 500–10,000 cfs (a conservative estimate — see our methodology). Below that it gets too low and bony; well above the top of the range it becomes pushy and then dangerous. We compare the live USGS reading to that range to produce today's verdict.
- How do I check James River levels?
- We read USGS gauge 02029000 — the same public data USGS publishes — about every 30 minutes and compare it to the runnable range for this reach. You can also view the raw gauge yourself at waterdata.usgs.gov.
- Is James River — Howardsville to Scottsville good for beginners?
- This section is rated Class I. At good levels it suits confident beginners and up, but it can have riffles or small rapids. Scout anything you can't see, and stay off it at high water.
- When is the best time to paddle James River here?
- Typically April–October, when flows are most reliable for this section. Spring can run high after rain or snowmelt; late summer can drop too low. Always check today's gauge reading rather than assuming.
- How long does it take to float James River — Howardsville to Scottsville?
- This reach is about 13 miles, roughly 6 hours at a relaxed pace. Higher water is faster; low water and headwinds are slower. Add time for stops.
Nearby sections
Rivanna River — Milton to Palmyra
Class II · 12 mi · est. range · 13 mi away
Good to paddle · 2,180 cfsJames River — Cartersville to Maidens
Class I · 13 mi · est. range · 24 mi away
Good to paddle · 1,270 cfsJames River — Bent Creek to Wingina
Class II · 11 mi · est. range · 26 mi away