Susquehanna River — Wilkes-Barre to Nanticoke: River Level Today — Can You Paddle It?
Verdict · updated Aug 18, 1:45 PM UTC
Good to paddle
Levels are within the typical runnable range for this section.
Estimated range
4,050 cfs
1.3 ft gauge height
USGS gauge 01536500
Runnable 800 – 18,000 cfs
What this means today
At 4,050 cfs the Susquehanna River is inside the runnable range but only 3,250 cfs above the 800 cfs floor, so it is sitting at the shallow end of what this reach runs at. A dry few days would take it under.
Over the last 24 hours it has barely moved, 4,280 cfs to 4,050 cfs. Daily means over the past 7 days have run between 4,330 cfs and 6,140 cfs, 29% lower at the end of the week than the start.
Paddling Wilkes-Barre to Nanticoke
Susquehanna River at Wilkes-Barre to Nanticoke is a 8-mile Class I run in Pennsylvania — easygoing moving water with light riffles and nothing technical. Most paddlers put in at Wilkes-Barre, PA access and take out at Nanticoke, PA access, a trip that runs about 3 hours at a relaxed pace.
Whether it's worth the drive comes down to flow. This section generally paddles well at 800–18,000 cfs (a conservative estimate — see our methodology). Much below that and the Susquehanna River gets low and bony, so you end up scraping gravel and walking the shallows; well above the top of the range it turns fast, cold and pushy, which is a more serious day than most casual boaters want. We read USGS gauge 01536500 about every 30 minutes and compare the live number to that window, so the verdict at the top of this page reflects conditions right now rather than a monthly average.
Flows here are usually most dependable April–October. Spring can run high after rain or snowmelt, and late summer often drops too low to float well — but the gauge always beats the calendar, so check today's reading before you go.
7-day flow trend
Section facts
- Difficulty
- Class I
- Length
- 8 mi
- Float time
- ~3 hr
- Best months
- April–October
- Take-out
- Nanticoke, PA access
Reading USGS gauge 01536500 — Susquehanna River at Wilkes-Barre, PA ↗ · runnable range is an estimate (see methodology)
FAQ
- What water level is good for paddling Susquehanna River — Wilkes-Barre to Nanticoke?
- This section is generally runnable at 800–18,000 cfs (a conservative estimate — see our methodology). Below that it gets too low and bony; well above the top of the range it becomes pushy and then dangerous. We compare the live USGS reading to that range to produce today's verdict.
- How do I check Susquehanna River levels?
- We read USGS gauge 01536500 — the same public data USGS publishes — about every 30 minutes and compare it to the runnable range for this reach. You can also view the raw gauge yourself at waterdata.usgs.gov.
- Is Susquehanna River — Wilkes-Barre to Nanticoke good for beginners?
- This section is rated Class I. At good levels it suits confident beginners and up, but it can have riffles or small rapids. Scout anything you can't see, and stay off it at high water.
- When is the best time to paddle Susquehanna River here?
- Typically April–October, when flows are most reliable for this section. Spring can run high after rain or snowmelt; late summer can drop too low. Always check today's gauge reading rather than assuming.
- How long does it take to float Susquehanna River — Wilkes-Barre to Nanticoke?
- This reach is about 8 miles, roughly 3 hours at a relaxed pace. Higher water is faster; low water and headwinds are slower. Add time for stops.
Nearby sections
Lehigh River — Lehighton to Walnutport
Class I · 12 mi · est. range · 30 mi away
Good to paddle · 906 cfsLehigh River — Walnutport to Bethlehem
Class I · 16 mi · est. range · 37 mi away
Good to paddle · 154 cfsLoyalsock Creek — Forksville to Loyalsockville
Class II · 17 mi · est. range · 41 mi away