Ocmulgee River — Amerson River Park (Macon) to Bullard: River Level Today — Can You Paddle It?
Verdict · updated Aug 26, 8:30 PM UTC
Too low to paddle
Not enough water to float well — expect scraping and walking. Wait for rain or a dam release.
Estimated range
535 cfs
5.6 ft gauge height
USGS gauge 02213000
Runnable 800 – 6,000 cfs
What this means today
At 535 cfs the Ocmulgee River is 265 cfs short of the 800 cfs this reach needs to float — that is the gap between today's reading and the bottom of the runnable range, not a small margin you can paddle through.
Over the last 24 hours it has gone from 592 cfs to 535 cfs, 10% down. Daily means over the past 7 days have run between 615 cfs and 838 cfs, 16% lower at the end of the week than the start.
Paddling Amerson River Park (Macon) to Bullard
Ocmulgee River at Amerson River Park (Macon) to Bullard is a 13-mile Class II run in Georgia — bouncy wave trains and the occasional small rapid. Most paddlers put in at Amerson River Park (Macon) and take out at Bullard (GA 87), a trip that runs about 6 hours at a relaxed pace.
Whether it's worth the drive comes down to flow. This section generally paddles well at 800–6,000 cfs (a conservative estimate — see our methodology). Much below that and the Ocmulgee River gets low and bony, so you end up scraping gravel and walking the shallows; well above the top of the range it turns fast, cold and pushy, which is a more serious day than most casual boaters want. We read USGS gauge 02213000 about every 30 minutes and compare the live number to that window, so the verdict at the top of this page reflects conditions right now rather than a monthly average.
Flows here are usually most dependable March–November. Spring can run high after rain or snowmelt, and late summer often drops too low to float well — but the gauge always beats the calendar, so check today's reading before you go.
7-day flow trend
Section facts
- Difficulty
- Class II
- Length
- 13 mi
- Float time
- ~6 hr
- Best months
- March–November
- Put-in
- Amerson River Park (Macon)
- Take-out
- Bullard (GA 87)
Reading USGS gauge 02213000 — OCMULGEE RIVER AT MACON, GA ↗ · runnable range is an estimate (see methodology)
FAQ
- What water level is good for paddling Ocmulgee River — Amerson River Park (Macon) to Bullard?
- This section is generally runnable at 800–6,000 cfs (a conservative estimate — see our methodology). Below that it gets too low and bony; well above the top of the range it becomes pushy and then dangerous. We compare the live USGS reading to that range to produce today's verdict.
- How do I check Ocmulgee River levels?
- We read USGS gauge 02213000 — the same public data USGS publishes — about every 30 minutes and compare it to the runnable range for this reach. You can also view the raw gauge yourself at waterdata.usgs.gov.
- Is Ocmulgee River — Amerson River Park (Macon) to Bullard good for beginners?
- This section is rated Class II. At good levels it suits confident beginners and up, but it can have riffles or small rapids. Scout anything you can't see, and stay off it at high water.
- When is the best time to paddle Ocmulgee River here?
- Typically March–November, when flows are most reliable for this section. Spring can run high after rain or snowmelt; late summer can drop too low. Always check today's gauge reading rather than assuming.
- How long does it take to float Ocmulgee River — Amerson River Park (Macon) to Bullard?
- This reach is about 13 miles, roughly 6 hours at a relaxed pace. Higher water is faster; low water and headwinds are slower. Add time for stops.
Nearby sections
Oconee River — Milledgeville to Dublin
Class I · 15 mi · est. range · 29 mi away
Too low · 258 cfsFlint River — Sprewell Bluff to Po Biddy Road
Class II · 19.8 mi · 36 mi away
Good to paddle · 1,260 cfsFlint River — Montezuma to Lake Blackshear
Flatwater · 12 mi · est. range · 45 mi away